Difference between revisions of "Team Hugo Cabret - Clock Project"

From ENGR005_2012
Jump to: navigation, search
(Created page with '==Project Description== Our group has decided to design and build a function clock from scratch using Solidworks and Matlab. ==Parts== ==References== 4) Add a link to a proje…')
 
Line 1: Line 1:
 
==Project Description==
 
==Project Description==
Our group has decided to design and build a function clock from scratch using Solidworks and Matlab.
+
Our group has decided to design and build a function clock from scratch using Solidworks.  The clock, operating on a specially ordered clock motor, will use a set of fifteen gears to display the seconds, minutes, and hours.  We will design these gears on Solidworks, print them with the 3D printer, and attach them to the shaft of the motor.
  
 
==Parts==
 
==Parts==
 +
We will need to order a 120 V clock motor with shaft operating at 60 Hz.  This will cost approximately $15 from
  
 
==References==
 
==References==
 +
 +
 +
 
4)  Add a link to a project proposal.  This proposal should include:
 
4)  Add a link to a project proposal.  This proposal should include:
 
         * 1-2 paragraphs describing the project,
 
         * 1-2 paragraphs describing the project,
 
         *  any necessary parts you will need, including cost and source for parts,
 
         *  any necessary parts you will need, including cost and source for parts,
 
         * any references (if necessary).
 
         * any references (if necessary).

Revision as of 16:17, 17 November 2012

Project Description

Our group has decided to design and build a function clock from scratch using Solidworks. The clock, operating on a specially ordered clock motor, will use a set of fifteen gears to display the seconds, minutes, and hours. We will design these gears on Solidworks, print them with the 3D printer, and attach them to the shaft of the motor.

Parts

We will need to order a 120 V clock motor with shaft operating at 60 Hz. This will cost approximately $15 from

References

4) Add a link to a project proposal. This proposal should include:

       * 1-2 paragraphs describing the project,
       *  any necessary parts you will need, including cost and source for parts,
       * any references (if necessary).