Team Hugo Cabret - Clock Project

From ENGR005_2012
Revision as of 16:34, 17 November 2012 by Cemery1 (Talk | contribs) (Project Description)

Jump to: navigation, search

Project Description

Our group has decided to design and build a functioning clock from scratch using Solidworks. The clock, operating on a specially ordered clock motor, will use a set of gears to display seconds, minutes, hours, and potentially days of the week. We will design the gears, face, and hands of the clock on Solidworks, and we will print them using the 3D printer. Because our motor has only one shaft, we will need fifteen gears to connect to the second hand, minute hand, and hour hand. The motor completes one revolution per minute; thus, the minute hand will run 1/60 of that frequency, and the hour hand must then run 1/12 of the frequency of the minute hand.

Parts

We will need to order a 120 V clock motor with shaft operating at 60 Hz. This will cost approximately $15 from _________. Additionally, we will need to design each of our 15 gears by hand on Solidworks.

References

4) Add a link to a project proposal. This proposal should include:

       * 1-2 paragraphs describing the project,
       *  any necessary parts you will need, including cost and source for parts,
       * any references (if necessary).